Creating a new SD card is only necessary if you want to set up your WebConnect co-router again. When the WebConnect co-router is delivered, the SD card is already pre-installed for immediate use.
How to configure the WebConnect Micro SD card
You will need
- a write drive for Micro SD cards
- a Micro SD card (e.g. 32 GB)
- BalenaEtcher App
- Download the newest WebConnect image file: Download.
Launching BalenaEtcher
Select Flash from File
In the following file dialogue select the image file
The next step is to select the target drive.
Select the drive in the card recorder with the SD card.
Click on Flash to start the process. All existing data on the card will be overwritten.
A system message may appear in which the process must be approved.
The writing process goes through several steps.
The process is completed with the Flash Complete message.
Important!
Now remove the card from the drive and reinsert it. Now the drive should open showing all files. Otherwise open the drive via the file explorer:
The SD card can now be inserted into the WebConnect device. To do this, disconnect the WebConnect from the power supply. After inserting, start the device. Further initialization is carried out by the device. After a few minutes, the subdomain can be called up and the device can be put into operation. The instructions for this can be found here: Set up WebConnect